Owner`s manual

59
Specifications
The correlation between published specifications and sonic quality is unreliable. A list
of numbers reveals virtually nothing. All technical measurements must be subject to
qualitative as well as quantitative interpretation.
Measurements of the Nº32 yield excellent results by any standards. However, only
those specifications that apply to its actual operation are included here.
Power consumption: 150W maximum
Mains voltage: 100V, 120V, 220V, 230V or 240VAC
at either 50 or 60Hz (set at the factory)
Overall dimensions: See “Dimensions”
Shipping weight: Controller: 60 lbs. (27 kg)
Preamplifier: 46 lbs. (21 kg)
Preamplifier Inputs: 3 pr. balanced on XLR
5 pr. single-ended on Madrigal RCA
(optional) 2 pr. phono on either XLR or Madrigal RCA
2 Controller/DC cable connectors
1 ground terminal
Preamplifier Outputs: 2 pr. balanced main output on XLR
2 pr. single-ended main output on RCA
1 pr. record output on XLR
2 pr. record outputs on Madrigal RCA
Controller Connectors: 1 IEC AC mains recepticle
1 earth ground terminal
2 Controller/DC cable connectors
1 3.5mm “mini” jack for IR input
1 3.5mm “mini” jack for trigger out
1 3.5mm “mini” jack for trigger in
3 Mark Levinson Link communications connectors
1 6 pin RJ-11 RS-232 port
2 8-pin RJ-45 control ports (PHASTLink™ compatible)
Gain: 0, 6, 12, or 18 dB in the line stage
either 40 or 60 dB in the optional phono module
Volume control range: 80.0 dB
Gain resolution: 0.1 dB steps above 23.0 in display (-57 dB)
1.0 dB steps below 23.0 in display (-57 dB)
Input overload:
when gain is set to +18 dB: 2V on XLR, 1V on RCA
when gain is set to +12 dB: 4V on XLR, 2V on RCA
when gain is set to +6 dB: 8V on XLR, 4V on RCA
when gain is set to 0 dB: 16V on XLR, 8V on RCA
Input impedance: 100k
Output impedance: less than 10 on XLR
less than 20 on RCA
Maximum output (MAIN outputs): 16V on XLR
8V on RCA
THD + N: less than 0.001%
Crosstalk, any input to any output,
input unterminated:
less than -120 dB
input terminated: less than -140 dB