Owner`s manual

50
To reset all settings of the Nº32 to the original factory settings,
1. Turn off power on the Controller
You may either unplug it from the ac mains or use the front panel
power button; standby will not do. Wait for a few seconds for the
power supply to drain.,
2. Restore power while holding both the record out and setup
buttons.
This process takes a few seconds, as a guard against accidental res-
toration of factory defaults.
3. Continue holding both buttons for about ten seconds after
the display reads “CLEAR SETUP?”
If you take your fingers off the buttons within these first ten sec-
onds or so, the operation will be cancelled, leaving your current
settings unchanged. If you persist in holding the record out and
setup buttons, the display will show “FACTORY” “SETUP” “RE-
STORED
” in sequence.
operating without a
preamplifier
It is also possible to operate the Controller without a Preamplifier be-
ing attached. This can be helpful if for some reason you need to set up
the system without having to actually listen to it (e.g., customizing the
names, phono loading for a known cartridge, etc.). The Preamplifier
may remain in its box while the Controller is preset to operate as it will
need to do when finally installed.
Normally, when you power up the Controller, it checks to ensure that it
can communicate with the Preamplifier properly. If either of both of
the DC cables has not been seated properly, the display will inform you
which one(s) need to be connected.
If you need to operate the Controller without the Preamplifier, power it
up while holding in the mute button. (This is easy to remember, since
your system will remain remarkably quiet until you connect and use
the Preamplifier.)