Owner`s manual

Using the Nº32 with Learning

Remote Controls

using the teach ir menu The teach ir menu within the setup menu lists all of the custom infra-

red commands available for the various functions of the Nº32 Refer-

ence Preamplifier.

In every case where a “toggle” command exists, both the normal toggle

function and positive control commands for the multiple states are

provided. Thus, the mute key functions as a toggle between mute and

unmute; but we also provide go mute and go unmute, since these

positive controls increase the reliability of macros in learning remote

control such as Madrigal’s own IRIQ.

To access these commands,

1 press setup once to enter the setup menu

2 turn the select knob until “Teach IR” is displayed

3 press enter once to toggle into the edit mode (where you

can choose which “teach ir” command you want

4 move the volume knob to select the command you want to

learn

5 press enter to transmit that command from the left side of

the display window

The display window will change to <--SENDING to indicate where

the infrared codes are being emitted.

technical note: The frequency of the infrared carrier upon which the

command are transmitted is 40kHz. This is the most

common carrier frequency of any used in remote

controls today, and should present no problem for any

learning remote control.

If your remote has difficulty learning the command

from the front panel of the Nº32 Controller, try varying

the distance, and shielding the remote control from

any flourescent lights in the area (which can interfere

with the learning process).