Owner`s manual

Remote Control

display

setup enter

mono

polarity balance

mute

select volume

standby

1 IR transmission window

Infrared (IR) control signals are sent through this window. Aim

the remote control toward the Nº32 when using the remote. For

the best results, the remote should be within ±45° of a line that is

perpendicular to the faceplate of the Controller. At more severe

angles (nearly parallel with the faceplate), try bouncing the

remote’s signal off a wall or other surface instead so as to have it

enter the display window of the Controller at a reasonable angle.

2 IR Transmit Indicator

This LED lights when IR control signals are being transmitted. If

it fails to light while you are pressing a button, or if it seems to be

lighting more dimly than usual, you may need to change the bat-

teries (see item 13).

3 Display Button

Duplicates the function of the display intensity button on the

front panel, cycling among four levels of brightness (including

“off”) for the display, allowing adjustment for various ambient

lighting conditions.

4 Setup Button

Duplicates the function of the setup button on the front panel,

allowing you to access menu functions of the Nº32 from your lis-

tening position. For example, if you have purchased the optional

phono modules, you can experiment with different phono loading

options while listening to music in your preferred chair. This flex-

ibility makes it much easier to determine the correct values for

phono loading.

5 Enter Button

Duplicates the function of the enter button on the front panel,

allowing you to save changes to menu items in the Nº32 from

your listening position.