Owner`s manual

11
Unpacking and Placement
unpacking Unpack your Nº32 Preamplifier and keep all packing materials for fu-
ture transport. Locate and remove all accessory items from the Acces-
sory Box within the Controller shipping carton. Accessories include:
1 detachable AC power cord 2 multi-pin DC cables
1 Nº32 remote control 2 AAA alkaline batteries
1
5
64" Allen key 1
3
32" hex driver
Also included with your new Mark Levinson component is a pair of
knit, white gloves to assist you in the initial unpacking and placement
of your new purchase. Please accept them as a token of our apprecia-
tion for having purchased one of our products.
installing the batteries
in the remote control
Using the supplied
5
64" Allen key, remove the two screws in the bottom
end cap of the remote control (i.e., the end opposite the IR transmitter
lens). Insert the two alkaline batteries found in the Accessories box, be-
ing careful to follow the polarity indications given on the inside of the
battery compartment. Replace the end cap and the screws, using the
Allen key.
If at some point you notice that your remote control seems not to be
performing as well as it once did, its batteries are probably running low.
Check the batteries periodically, and replace batteries before they are
dead. (Fully discharged batteries are prone to leaking corrosive
chemicals—the greenish gunk you may have seen around battery ter-
minals of other remote controls.)
placement The Nº32 should be placed close to your source equipment, thus keep-
ing interconnect cabling short. We strongly recommend mounting each
chassis of the Nº32 on its own shelf to allow for proper ventilation.
continuous operation The Nº32 is designed for continuous operation—it is designed to be
connected to the AC mains at all times for the best performance. While
we also include a front-panel power switch that actually disconnects
the Nº32 from the AC mains, we recommend you use the standby but-
ton instead, which leaves the Nº32 warmed up and sounding its best at
all times.