Specifications

66
Programming PAV Functions If you inadvertently overwrite one or more PAV commands in your PAV remote
control, never fear—you don’t have to obtain another PAV remote in order to
re-teach your own its PAV-specific commands. The PAV itself can send all of
the necessary IR commands from its main display window, enabling you to
teach the PAV remote both its pre-programmed commands and a few other,
optional commands which you might find useful.
When using the PAV itself to teach new commands to your remote control,
your remote will have to be in its learning mode (obviously). Therefore, you
must navigate the on screen menus by using the buttons on the front panel of
the PAV. The buttons on the front panel you need to use are as follows:
•
recall: the menu function is provided by the recall button. In
order to activate the on screen menus rather than simply recall-
ing the calibrated output level settings, press and hold the recall
button until the front panel lights are turned off (about ten sec-
onds). From this point on until you exit the menu system, the
recall button will perform exactly as the menu button on the re-
mote control would.
• master: the front panel master button is also conveniently
placed adjacent to the volume +/– buttons, and serves the same
purpose as the one on the remote control.
• volume +/–: the front panel volume +/– buttons also operate in
the same fashion as their counterparts on the remote control.
• standby: the enter function is provided by the standby button
on the front panel (when the PAV is in menu mode). It is delib-
erately set apart from all of the other menu-related buttons to
make permanent changes of system parameters a deliberate act.
1 ENTER THE SETUP MENU
2 SELECT “REMOTE CONTROL,” AND THEN “TEACH REMOTE”
3 TO RE-LEARN THOSE FUNCTIONS WHICH HAVE CORRESPONDING
FRONT PANEL BUTTONS, CHOOSE “PANEL BUTTONS”
The on screen display will prompt you to press any button. Line up the
IR window of the PAV remote control with the center of the main display
of the PAV, at a distance of approximately 6"-12". Select the to-be-learned
button on the remote, then press the corresponding button on the PAV.
Notice that a yellow LED in the main display lights up briefly after you
press a button. This LED indicates that the PAV is transmitting the com-
mand which corresponds to the button you just pushed. You may repeat
this process until all buttons have been learned.
Tip: save the teaching of the recall button for last, since its func-
tion as the menu button’s “double” will result in the on screen
display reverting to the previous menu after it transmits its
signal.
4 TO RE-LEARN BUTTONS WHICH EXIST ONLY ON THE REMOTE
CONTROL, CHOOSE “REMOTE ONLY”
From the teach remote menu, select remote only. The on screen display
will now look something like this (see next page):
PRESS
BUTTON
MENU
ENTER
DISPLAY
ON SCREEN
THX
STATUS
LATE NIGHT
DUAL DRIVE
TOGGLE
SURROUND
MODES
PATH
MISC
CONTROL
CONTROL
TRIG 1 ON
CONTROL
TRIG 1 OFF
CONTROL
TRIG 2 ON
CONTROL
TRIG 2 OFF
SUB/
CROSSOVER
PANEL
BUTTONS
REMOTE
ONLY
DIRECT
ACCESS
SPECIAL
TEACH
REMOTE