Owner`s manual

36
special commands table
hard assignment for operate CMD1
hard assignment for standby CMD2
hard assignment for system operate CMD3
hard assignment for system standby CMD4
hard assignment for record on CMD5
hard assignment for record off CMD6
display intensity to off CMD7
display intensity to medium CMD8
3 Momentarily press the mode button to transmit that code
Line up the IR window of your remote control with the left side of
the display of the Nº360, at a distance of approximately 2"-6". Se-
lect the to-be-learned button on the remote, then fire the selected
code from the Nº360 by pressing mode.
(If you are uncertain as to how to prepare your remote control for
learning new commands, refer to the instructions provided with
the remote control.)
5 Repeat the process of “teaching” new special commands
until all desired commands have been learned by your re-
mote control.
If you take longer than approximately ten seconds between button
pushes, the Nº360 will time out and return to normal operation.
If this occurs, return to step #1 in this section.
6 When finished, Return to normal operation by allowing the
Nº360 to “time out”
The Nº360 will “time-out” and return to normal operation after
approximately ten seconds, or you can force it back to normal op-
eration by “camping on” the teach ir button.