Owner`s manual

2 Input number

This part of the Nº360’s display shows the input number of the se-

lected digital source, according to the connections on the rear

panel (see “Rear panel, Nº360”) and to the front panel button

used to access that input.

3 Sampling frequency

This part of the Nº360’s display normally shows the sampling fre-

quency

of the digital input being processed, expressed in kilohertz.

The digital sampling frequency of the incoming signal will be

shown, in “shorthand” form:

32k, 44k, 48k, or 96k (44k is shown

in the main illustration on the opposite page). When an HDCD

signal is being received and decoded, this area will show HDCD in-

stead of a sampling frequency.

After you press one of the source selection buttons (say, going

from input 1 to input 5), the Nº360 will reduce the volume and

the display will show:

While the Nº360 is attempting to lock onto a different digital sig-

nal, the display will show (assuming you have renamed input 5 for

your DAT):

If no digital signal is present (if the source is turned off, is im-

properly connected, or is disconnected), the display will show: