Specifications

Basic Operation

Before operating your CDD, take a minute to become familiar with its controls

and their locations. (See “Front Panel” and “Remote Control.”)

Loading a CD To load a CD:

1. Enable the CDD’s controls by pressing standby if in standby.

2. Press stop/drawer to open the drawer.

3. Place a CD into the recess of the drawer, label side up. Handle the

CD by the outer edges and center hole only.

4. Press stop/drawer.

Playing a CD To play all tracks on the CD, press the play/pause button. All tracks will play in

order. Play will stop automatically at the end of the CD.

To begin play with a track other than the first track:

1. Before pressing play/pause, press next until the number of the

desired track shows on the Display. If you pass the track you want

to play, you can “back up” by pressing prev. (You may also select

the track directly using the numbered buttons on the Remote Con-

trol.)

2. Press play/pause to begin playing that track. The remaining tracks

will play in order. Play will stop automatically at the end of the CD.

Pause To suspend play while a CD is playing, press play/pause. To resume play at the

same point, press play/pause again.

If left in pause for about two minutes, the transport will stop spinning automati-

cally and the laser will turn off (thereby enhancing the longevity of both). Press-

ing play/pause again will resume play at the point where play/pause was first

pressed, after a short delay to find the correct starting point.

Random Play Using the Remote Control, you may have the CDD play tracks totally at random.

To do this, press the rndm key, then press play. The random LED will illuminate

to indicate the random play mode. To cancel random play, press rndm a second

time, or stop.

Navigating the Disc You may skip to another track any time while a CD is playing. To move to an-

other track, press next (to go forward) or prev (to go backward) until the number

of the track you want to play shows on the Display. (You may also select the track

using the numbered buttons on the Remote Control.) Play will resume as soon as

the pickup reaches that track.

You may search for a particular passage on the CD using fast forward and

rewind, by pressing and holding the next and prev buttons (respectively). Use the

reduced-volume audible scan available during these modes to search the CD until

the laser pickup reaches the passage you want to hear.