Specifications

25
Setup and Installation
Caution! For your protection, review “Important Safety Instructions”
before you install your CDD.
Connecting AC Mains Plug the female end of the AC power cord into the appropriate socket on the rear
panel of the CDD, being certain to seat it firmly, all the way into the receptacle.
Double-check to make sure that the voltage indicated on your CDD corresponds
to the normal voltage for your country. (Connecting a 120-volt CDD to a 220-volt
AC outlet is not a good idea, and will result in damage to the unit.) If so, plug
the male end of the power cord into the wall outlet.
Making Digital
Audio Connections
The CDD incorporates XLR, BNC and RCA electrical output connectors for provid-
ing the digital audio signal (DAS) to the digital audio processor. (See Rear panel,
CDD, above.) An optional ST optical connector may also be installed by your
dealer should you require one. Please check with your dealer regarding price and
availability if you need ST optical.
For electrical digital interconnection, we recommend Madrigal MDC cable. MDC-1
is designed for 110Ω AES/EBU interconnection (via XLR connectors); MDC-2 is
designed for 75Ω S/PDIF interconnection (via either RCA or BNC connectors).
Both cables are available in various lengths from your Proceed dealer.
Using an appropriate cable, connect an output of your CDD to a suitable input of
your digital processor.
To help with special installations and custom cabinetry, drawings are included in
this manual. (See Dimensions).