Manual

If a 10 second reading rate is acceptable, click the “Start Device” menu bar option to start the
device. Wait for a dialog box to appear that indicates the device has been started successfully.
Unplug the interface cable, and replace the stainless steel watertight plug.
Changing the Reading Rate
If a different reading rate is desired, for example to extend the logging time, or to more
accurately record gust values, the engineering units gain will have to be reprogrammed on the
device.
MadgeTech, Inc.
[phone] Phone
[phone] Fax
www.madgetech.com
[e-mail]
PO Box 50
Warner NH 03278
Setting Device Units for the Wind110
Using M/Ss
1. Connect the Wind110 to the PC that has the MadgeTech software installed.
2. Go to Device->Identify and Read Status.
3. In the Device Detail window click on the Device Detail tab and then click the Engineering
Units button on the lower right of the window.
4. When the Engineering Units window opens, click on the Device Units Wizard button.
Wind Tech Note REV A 2009.03.30 page 2 of 4