MG-TB-832 ASSEMBLY INSTRUCTIONS Do not throw away the packaging material until the assembly is complete, To protect the product, assemble this item on a soft surface such as a cardboard or a carpet. While assembling the product, first tighten the bolts/screws up to 50%. Once all parts are in place, only then fully tighten the bolts/screws! CARE INSTRUCTIONS Wipe only with a soft & dry cloth. To protect product, avoid the use of chemicals and household cleaners.
T E Flat Head Allen Bolt M8x40mm 4X HHH H 3 Allen-Key @5mmx110mm, 1X HARDWARE PROVIDED Washer Lock Washer D20mmx@8mm D15mmxdP@8mm Flat Head Countersunk Allen Bolt Screw M8x60mm 4X40mm 4% 4% J Brackets 10mm 2X H Wall Plug 4X = K Nylon Strap 300x12X8MmMm 2X
STEP ASSEMBLY INSTRUCTIONS Turn the Table Top (A) upside down and align the Table Legs (B) on top of the holes as highlighted in red above, Note While assembling the product, first tighten the bolts/screws up to 50%.
STEP 2 Once aligned, begin to place the Washers (C&D) and Bolts (E&F) on the legs. Use bolt E on the narrow parts and bolt F on the broad parts of the Table Legs.
STEP 3 Using the Allen-Key (1) tighten all Bolts and Washers to secure all four legs in place.
STEP G Place the bracket on the wall and make marks where the cabinet needs to be attached. Drill holes in place of the marks. Using a hammer, insert Wall Plugs (H) in the holes you Just marked.
STEP 7 ~ SCREW DRIVER Now, place the Brackets (J) on top of it and insert Screws (Q). Tighten completely with the help of a Screwdriver.
STEP Attach one end of the Nylon Strap (K) to the brackets on the wall and the other end to the Brackets on the cabinet. Lock and pull to fasten the strap.
