User`s guide

QuickStream DV - Portable FireWire Hard Disk DV Recorder - 13
green “POWER” button.
4. Once the QuickStream DV has finished synchronizing with the DV
camcorder the green “POWER” button will remain steadily lit.
Press the “REVIEW” button and the QuickStream DV will playback the entire last
recorded clip over your DV camcorder’s LCD display. You may stop the
playback at any time by pressing the “Review” button again.
Quick-Erase Button
At the far right of the interface control panel of the QuickStream DV is a recessed
button marked “ERASE.” This button will erase all DV files recorded by the
QuickStream DV from the drive and can only be done while the QuickStream DV
is connected to a DV camera.. Please follow the instructions below to use this
function:
5. Turn on your DV camcorder and set it to “Camera” mode.
6. Connect your DV camcorder to your QuickStream DV via the
FireWire/IEEE1394/i.LINK port.
7. Turn the QuickStream DV on by pressing the green “POWER” button.
8. Once the QuicksStream DV has finished synchronizing with the DV
camcorder the green “POWER” button will remain steadily lit.
9. Using the tip of a pen or other sharp object, depress the “ERASE” button
for 5 seconds or more and then release.
10. The interface lights will blink rapidly and then stop… indicating that any
clips previously recorded by the QuickStream DV have been erased.
Internal, Rechargeable, Lithium-Ion Polymer Battery
The QuickStream DV contains a state-of-the-art rechargeable Lithium-Ion
polymer battery capable of running the QuickStream DV in standby mode for
about 3-4 hours and to record continuously for about 90 minutes per charge.
When the QuickStream DV is plugged into an AC Adapter, or connected to a
FireWire port which supplies bus power, the drive automatically recharges its
battery using whatever leftover current is available. A blue LED in the interface
panel lights up to indicate that the battery is charging and turns off when the
battery is fully charged. Charge time from empty to fully charged is about 2
hours when used with the supplied AC adapter and the QuickStream DV is
powered off. Expect longer charge times if the QuickStream DV is in use during
charging.
☞ If the QuickStream DVs battery is below a certain charge level, then when
the “POWER” button is pressed, the “POWER” LED will flash quickly. Since the
battery power is so low, the recording function is disabled. During recording, if