User`s guide

QuickStream DV - Portable FireWire Hard Disk DV Recorder - 12
are individual shots in the form “CLIPaabb.mov (or .dv or .avi etc.). The first two
digits “aa” after “CLIP” refer to a particular shot and the last two digits pertain to
segmented clips belonging to that shot. For example, individual shots always
begin with clips named CLIP0000.mov, CLIP0100.mov, CLIP0200.mov etc. If,
for example, the shot beginning with “CLIP0400.mov” lasts longer than the 1.8GB
(or 1GB for .mov) size then the proceeding segmented clips created
automatically by the QuickStream DV are named CLIP0401.mov, CLIP0402.mov,
CLIP0403.mov… up to CLIP0499.mov. In this way you can always tell which
clips belong to a particular shot.
DV Recording from DV Camcorder in VCR/VTR Mode or from a DV Deck
1. Make sure the “MASTER” power switch on the QuickStream DV is in the
“ON” position.
2. If you have not already done so, turn on your DV camcorder or DV deck.
3. Now connect the QuickStream DV to your DV camcorder’s, or DV deck’s,
FireWire/IEEE1394/i.Link port.
4. Turn on the QuickStream DV by pressing the “POWER” button.
5. Cue the DV Tape on your DV camcorder or DV deck to the point where
you want to record to the QuickStream DV and hit “Pause”.
6. The QuickStream DV recognizes your DV camcorder’s, or DV signal and
prepares itself. In just a few moments the green “POWER” button will
remain lit and the QuickStream DV is ready.
7. Press the “RECORD” button on the QuickStream DV in order to “Start”
recording and press the “Pause” button again on your DV camcorder or
DV deck to begin playing. The QuickStream DV will record whatever
video is recorded to the DV tape inside your DV camcorder or DV deck
until the tape is finished or there is no more recorded video on the tape.
8. When finished, power off the QuickStream DV by pressing the “POWER”
button.
9. If you will be transporting or storing the QuickStream DV for any length of
time, slide the “MASTER” power switch away from the “ON” position.
Review Button
Located in between the Power and Record button is the Review button. This
button allows you to see your last recorded clip via FireWire on your DV
camcorder’s LCD display. Follow these instructions in order to utilize this feature
of the QuickStream DV
1. Turn on your DV camcorder and set it to “VCR/VTR” mode.
2. If not already connected, connect your DV camcorder to your
QuickStream DV via the FireWire/IEEE1394/i.LINK port.
3. If not already powered on, turn the QuickStream DV on by pressing the