User Guide

Adobe LiveCycle Invoking LiveCycle Assembler Using LiveCycle Workflow and Watched Folder
Installing and Configuring LiveCycle for JBoss Configuring an Assembler QPAC in a workflow process 106
Configuring an Assembler QPAC in a workflow process
When you create a new workflow process in LiveCycle Workflow Designer, you must create variables that
will be used by the workflow process. When you add the Assembler QPAC to the workflow, you must set
the action properties for the QPAC. The action properties use the variables that you created.
The selections you make on the Action Properties dialog box depend on whether you are using a dynamic
or static DDX file.
Note: The variable names used in this chapter, such as
<inputddx> and <inputdocmap>, are
user-defined in LiveCycle Workflow Designer; you can use any name when you create the variable.
Variables for the Assembler QPAC
Action properties for the Assembler QPAC
Variable Property values
<inputdocmap>
Type: map of document
in: selected
out: not selected
required: not selected
<inputddx>
(required for dynamic
DDX file only)
Type: document
in: selected
out: not selected
required: not selected
<outputmap>
Type: map and document
in: not selected
out: selected
required: not selected
<joblog>
(not required when
Logging Level is set to Off )
Type:
Document
in: not selected
out: selected
required: not selected
Type of workflow Select on Input tab Select on Output tab
Using Watched Folder with a
dynamic DDX file
Use a Document Variable to load the
DDX file: Click the ellipsis button and
select the
<inputddx> variable.
Input Document Map Variable:
Select the
<inputdocmap> variable.
Output Document Map: Click
the ellipsis button and select the
<outputmap> variable.