User Guide

The two source fonts are now dynamically linked to the
new font. If you open any Outline window in the new font,
you will see both source outlines in the Template layer (like
in this illustration).
Any changes you make to the source font’s outline will
show in the Template layer, but not change the new
blended font’s outline unless you choose “Blend Fonts”
again.
To change selected destination characters:
1. Make some changes to a character in one of your
Source fonts.
The change is reflected in the Untitled font character’s
Template layer.
2. Click on the Selected destination character’s radio
button.
3. Click “OK.”
Fontographer will automatically reblend the characters.
4. Turn off the Template layer and “Show Points” and
then choose “Preview” from the View menu to view
your new character.
Fontographer User's Manual
2: Creating New Fonts Page #35