User Guide

Table Of Contents

loadMovie() 23

Operands

url A string specifying the absolute or relative URL of the SWF file to load. A relative path

must be relative to the SWF file at level 0. Absolute URLs must include the protocol

reference, such as http:// or file:///.

target A reference to a movie clip or a string representing the path to a target movie clip.

The target movie clip is replaced by the loaded SWF file.

method An optional string parameter specifying an HTTP method for sending variables.

The parameter must be the string

GET or POST. If there are no variables to be sent, omit this

parameter. The

GET method appends the variables to the end of the URL and is used for small

numbers of variables. The

POST method sends the variables in a separate HTTP header and is

used for long strings of variables.

Description

Function; loads a SWF file into Flash Lite while the original SWF file plays.

To l o a d a S W F fil e into a specific level, use the

loadMovieNum() function instead

loadMovie().

When a SWF file is loaded into a target movie clip, you can use the target path of that movie

clip to target the loaded SWF file. A SWF file loaded into a target inherits the position,

rotation, and scale properties of the targeted movie clip. The upper-left corner of the loaded

image or SWF file aligns with the registration point of the targeted movie clip. However, if the

target is the root timeline, the upper-left corner of the image or SWF file aligns with the

upper-left corner of the Stage.

Use the

unloadMovie() function to remove SWF files that were loaded with loadMovie().

Example

The following example loads the SWF file circle.swf from the same directory and replaces a

movie clip called

mySquare that already exists on the Stage:

loadMovie("circle.swf", "mySquare");

// Equivalent statement: loadMovie("circle.swf", _level0.mySquare);