User Guide

30 Chapter 2: The Fireworks Object Model
The following table lists the methods of the ContourNode object, along with their parameters.
succY
float The y coordinate of the contour node’s
following control point.
x
float The x coordinate of the contour node’s main
control point.
y
float The y coordinate of the contour node’s main
control point.
Method Parameter Definition
RegisterMove()
object The RegisterMoveParms object containing
the move parameters. Use
smartShape.GetDefaultMoveParms() to
obtain this object, then adjust properties as
needed. For a list of properties, see
“RegisterMoveParms object” on page 56.
RegisterLinearMove()
point A point, which in combination with the node
point, defines the line to move along.
object The RegisterMoveParms object containing
the move parameters. Use
smartShape.GetDefaultMoveParms() to
obtain this object, then adjust properties as
needed. For a list of properties, see
“RegisterMoveParms object” on page 56.
RegisterCircularMove()
point The center point for the circular movement.
object The RegisterMoveParms object containing
the move parameters. Use
smartShape.GetDefaultMoveParms() to
obtain this object, then adjust properties as
needed. For a list of properties, see
“RegisterMoveParms object” on page 56.
RegisterPolygonMove()
point The center point for the polygon.
object The RegisterMoveParms object containing
the move parameters. Use
smartShape.GetDefaultMoveParms() to
obtain this object, then adjust properties as
needed. For a list of properties, see
“RegisterMoveParms object” on page 56.
Property Data type Notes