User Guide

Document functions 149
Returns
true
if the file is successfully exported; false otherwise.
Description
Exports the document as specified.
dom.fillSelectedPixels()
Availability
Fireworks 3.
Usage
dom.fillSelectedPixels(clickPt, p1, p2, p3, bFillSelectionOnly, tolerance,
edgemode, featherAmt)
Arguments
clickPt
A point that specifies the x,y coordinates of the pixel to be filled or generated (see
“Point data type” on page 11).
p1, p2, and p3 Points that specify the fill-vector. These arguments are ignored if the current fill
does not use a fill-vector.
bFillSelectionOnly If bFillSelectionOnly is true, the remaining arguments are ignored.
If it is
false, the current pixel selection is ignored, and a new one is generated using the values
passed for
tolerance, edgemode, and featherAmt. (This behavior is the same as if the Magic
Wand tool were used at the
clickPt location.)
tolerance An integer between 0 and 255, inclusive, that specifies the tolerance for
selecting pixels.
edgemode Acceptable values for edgemode are "hard edge", "antialias", and "feather".
featherAmt An integer between 0 and 32,000, inclusive, that specifies the number of pixels to
feather. This value is ignored if the value of
edgemode is not "feather".
Returns
Nothing.
Description
When the selection is an image and Fireworks is in bitmap mode, this method fills the selected
pixels with the current fill or generates a new pixel selection.
Example
The following command fills the selection with a hard edge, and the tolerance set to 32.
fw.getDocumentDOM().fillSelectedPixels({x:207, y:199}, {x:207, y:199}, {x:207,
y:199}, {x:207, y:199}, false, 32, "hard edge", 0);