User Guide

Document functions 189
Description
Exports the document as specified.
dom.fillSelectedPixels()
Availability
Fireworks 3.
Usage
dom.fillSelectedPixels(clickPt, p1, p2, p3, bFillSelectionOnly, tolerance,
edgemode, featherAmt)
Arguments
clickPt A point that specifies the x,y coordinates of the pixel to be filled or generated (see
“Point data type” on page 12).
p1, p2, and p3 Points that specify the fill-vector. These arguments are ignored if the current
fill does not use a fill-vector.
bFillSelectionOnly If bFillSelectionOnly is true, the remaining arguments
are ignored. If it is
false, the current pixel selection is ignored, and a new one is generated
using the values passed for
tolerance, edgemode, and featherAmt. (This behavior is the
same as if the Magic Wand tool were used at the
clickPt location.)
tolerance An integer between 0 and 255, inclusive, that specifies the tolerance for
selecting pixels.
edgemode Acceptable values for edgemode are "hard edge", "antialias", and "feather".
featherAmt An integer between 0 and 32,000, inclusive, that specifies the number of pixels
to feather. This value is ignored if the value of
edgemode is not "feather".
Returns
Nothing.
Description
When the selection is an image and Fireworks is in bitmap mode, this method fills the
selected pixels with the current fill or generates a new pixel selection.
Example
The following command fills the selection with a hard edge, and the tolerance set to 32:
fw.getDocumentDOM().fillSelectedPixels({x:207, y:199}, {x:207, y:199},
{x:207, y:199}, {x:207, y:199}, false, 32, "hard edge", 0);