User Guide

6 Chapter 1 Installing ColdFusion Server in Windows
Installing SNMP in Windows NT 4.0 Server and Windows 2000
Server
Managed data is accessible in ColdFusion Server 5 Enterprise Edition through the
Simple Network Management Protocol (SNMP) Management Information Base
(MIB) for Advanced ColdFusion Application Management features. You can
integrate this information with your third-party system management tools. These
tools provide a way for you to manage diverse components of your enterprise from a
management station in your network.
If you want to use the ColdFusion Server MIB features, you must install SNMP before
installing ColdFusion Server. For instructions, see the following procedures.
To install the SNMP service in Windows NT 4.0:
1 From the Start menu, select Settings > Control Panel > Network > Service Tab >
Add > SNMP Service.
2 The installation begins. When prompted, insert your Windows installation
CD-ROM.
3 Start the SNMP trap service.
Note
If you chose to overwrite new files during the SNMP installation, you must re-apply
your most recent operating system Service Pack after the SNMP installation because
the SNMP install includes some older files.
To install the SNMP service in Windows 2000:
1 From the Start menu, select Settings > Control Panel > Add/Remove Programs >
Add/Remove Windows Components.
2 Click Management and Monitoring Tools and Details.
3 Select Simple Network Management Protocol, and click OK.
4 To begin the installation, click Next.
SNMP
†
Required only for MIB functionality. For
instructions, see “Installing SNMP in Windows
NT 4.0 Server and Windows 2000 Server” on
page 6 and “Configuring SNMP MIB” on page
36.
* Windows NT 4.0 Server only
† Windows 2000 Server only
Operating
System Update Where to find it
install.book Page 6 Thursday, May 10, 2001 12:59 PM