User Guide
Table Of Contents
- Installing and Configuring ColdFusion Server
- Contents
- Welcome to ColdFusion Server
- Installing ColdFusion Server in Windows
- Installing ColdFusion Server in Solaris
- Installing ColdFusion Server in Linux
- Installing ColdFusion Server in HP-UX
- Basic ColdFusion Server Administration
- Managing Data Sources
- Preparing Your Server for ClusterCATS
Adding Data Sources for ColdFusion 115
Adding Data Sources for ColdFusion
The process for adding a data source in the ColdFusion Administrator is the same,
whether you use an ODBC, OLE DB, or native driver. The following procedure adds
an ODBC data source that uses a SQL Server driver.
To add a data source to ColdFusion:
1Open the ColdFusion Administrator.
2 Under Data Sources, click a link to specify a type of data source to add:
• ODBC
• OLE DB (available only on Windows NT/2000)
• Native
The Data Sources page displays Data Source Names (DSNs) of that type that are
available to ColdFusion:
3 Enter a name for the new data source and select a driver from the drop-down list.
Note
Do not name a ColdFusion data source Registry or Cookie; these words are
reserved for use by ColdFusion.
4Click Add.
install.book Page 115 Thursday, May 10, 2001 12:59 PM