User Guide

Debug Settings 89
Debugging IPs
You use the Debugging IPs page to restrict debugging output to one or more IP
addresses. You can add and remove IP addresses.
Warning
If you do not specify IP addresses and debugging options are active, debug output
displays for all users.
To allow debug output to an IP address:
1 On the Debugging IPs page, enter an IP address. Click Add.
2 To add the IP address of the computer you are using, click Add Current.
To disable debug output to an IP address:
1 On the Debugging IPs page, select an IP address.
2 Optionally, repeat Steps 1 and 2 for other addresses.
3 Click Remove.
install.book Page 89 Thursday, May 10, 2001 12:59 PM