Operation Manual

- 16 -
Other Devices
You can connect an external audio/video device to the unit.
1. Connect the external device with the supplied AV cable.
2. Touch the upper left corner to display the main menu.
3. Touch [AV1] front input or [AV2] rear input.
Reset
When the unit hangs up, you can reset it.
Press [ RESET ] with a ball-point pen or similar tool.
Tip:
When the unit has been reset, all the settings will return
to default settings.
Replace a Fuse
If there is no power, the fuse may be damaged and need to be replaced.
1. Take out the unit from dashbpard.
2. Check all electrical connections.
3. Buy a fuse that matches the amperage of the damaged fuse.
4. Replace the fuse while the units power is disconnected.
Navigation (GPS)
1. Touch the upper left corner to display home menu.
2. Touch [Navigation], to start the navigation software.
3. For instructions on using of navigator, refer to the manufacturer’s user manual.
Nota:
While Navigation is running, you can view the previously selected source by press the [NAVI]
button. Press again the [NAVI] button to return to the navigation mode.
Where it was used the Bluetooth function you can display the navigation following the procedure
described above.
Other Modes
Programming SWC
Touch [ SWC ], the SWC menu will display.
The scroll bar text will indicate the sequence for programming functions:
1. Press reset to start setting
2. Reset done!
3. Press the key on screen to select the function
4. Press the corresponding button of the steering wheel to confirm the selection
5. Repeat steps 3 and 4 until the completion of available SWC functions
6. Press Save to complete
7. Press Exit
M-DVD5000 User manual_ENG.indd 16 28/12/2016 09:05:28