Operation Manual

1. Inset mounting collar into the dashboard, and

bend the mounting tabs out with a screwdriver.

Make sure that lock lever is flush with the

mounting collar (not projecting outward).

2. Secure the rear of the unit.

After xing mounting bolt and power connector,

x the rear of the unit to the car body by rubber

cushion.

3. Insert trim plate.

Installation Guide

Installation Procedures

First complete the electrical connections, and then check for

correctness.

Reset

Press button to flip down the panel. Then press the RESET

button with a pointed object to reset the unit to the original status.

Note: Press the RESET button will erase the clock and stored

stations.

Installation Opening

This unit can be installed in any dashboard having an opening as

shown below.

The dashboard should be 4.75mm - 5.56mm thick in order to be

able to support the unit.

Lock lever

Important:

Remove these two screws before installation. Otherwise,

the DVD player will not work.

183mm

52mm

Mounting bolt

rubber cushion.