E nglish ALDINET S.P.A. VIALE C.
Safety Precautions 1. Only connect the unit to a 12-volt power supply with negative grounding. 5. Never expose this unit, amplifier, and speakers to moisture or water for preventing electric sparks or fires. 2. Never install this unit where the operation & condition for safety driving is restrained. 6. Please don't change the fuse on the power cord without professional guidance, using improper fuse may cause damage to this unit or even cause fire.
Safety Information Contents WARNING Safety Precautions.................................................1 Safety Information..................................................2 Panel Controls........................................................3 Remote Controls................................................. 4-5 Getting Started.......................................................6 USB/SD/MMC MP3 Playback.................................7 General Operation..............................................
Panel Controls Power On/Off: Press to turn On/Off the unit. 1 2 3 4 Panel Open Button 1: Play/Pause Button 2: Intro Play - Rotate the knob to adjust volume level. - Push to select BAS/TRE/BAL/FAD/BRI/CON/SAT, Rotate the knob to adjust level.
Remote Controls Power On/Off: Press to turn on/off the unit.
Remote Controls Replacing the lithium battery of remote control unit. Remote control operating range The remote control can operate within a distance of 3~5m. When the range of the operation of the card remote control becomes short or no functions while operating, replace the battery with a new lithium battery. Make sure the battery polarity replacement is correct. 1. Pull out the battery holder while pressing the stopper. 2. Insert the button-type battery with the stamped(+) mark facing upward.
Getting Started Press the button to open the panel and press Light up when you slide the panel down; flashes when you remove the panel. to eject the disc. Note: Pressing the RESET button by inserting a pointed tool such as the end of an unbent paper clip.
USB/SD/MMC MP3 Playback 1. L oading SD/MMC card USB/SD/MMC Notes Open the panel and insert the SD/MMC card into the slot. Close the panel, the unit will read the file of the card automatically. USB functions (flash memory type) MP3 music play 1. SD/MMC card support 2. USB flash memory 2 in 1 (SD/MMC ) support 3. Support FAT 16 & FAT 32 4. File name: 32 byte/dir name: 32 byte/tag name: 32 byte 5. Tag (id3 tag ver 2.0) - title/artist/album: 32 byte support 6. Multi card reader not support 7. USB 1.
General Operation Switching On and Off 1. Press to turn on the unit. 2. Press SRC once or more to select your desired function: DISC, Tuner (Radio), USB & SD/MMC, AV-in. 3. Press to power off (press more than 2 seconds). 4. When you switch off the system or car ignition, the settings, tuner presets and the volume level will be retained in the unit's memory. VOL Knob Function Press the knob once to select BASS/TREBLE/BALANCE/FADER/BRIGHTNESS/CONTRAST/SATURATION, rotate the knob to adjust.
Rotary Knob Menu EQ mode Press the knob more than 2 seconds to enter menu mode, then each press changes the mode as follows: EQ MODE LOUD BEEP 12 /24 MODE TA MODE RETUNE PARKING TA-VOL VOL-MODE A-VOL SUBWOOFER SUBW-VOL Rotate the knob to select EQ sound effect: ROCK - POP - CLASSIC - FLAT - EQ OFF LOUD mode Rotate the knob to choose loud on or off.
Rotary Knob Menu BEEP ON/OFF mode TA mode Rotate the knob to choose button beep sound on or off. Rotate the knob to choose TA ALARM or TA SEEK mode. If the TA (Traffic Announcements) is turned on and there is no traffic program identification code received in the specified time, no TA/ TP will display and either TA ALARM or TA SEEK will be activated. TA ALARM mode : Alarm is turned on. TA SEEK mode: TA SEEK is automatically activated. 12/24 mode Select 12 hours mode or 24 hours mode.
Rotary Knob Menu RETUNE mode TA-VOL Rotate the control to choose RETUNE-S or RETUNE-L. RETUNE-S or RETUNE-L is time length selection of TA SEEK retune interval. RETUNE-S: Short, TA SEEK Retune interval is 45 seconds. RETUNE-L: Long, TA SEEK Retune interval is 180 seconds. REMARK: RETUNE mode functions for TA during TA SEEK mode only. Rotate the knob to choose TA-VOL level. VOL - MODE Rotate knob to choose VOL LAST, the turn-on volume level is the volume level of latest power off.
Rotary Knob Menu A - VOL SUBWOOFER Rotate the knob to choose A-VOL level. Rotate the knob to choose SUBWOOFER frequency: 80Hz, 100Hz, 120Hz. SUBW - VOL(optional) Rotate the knob to choose SUBWOOFER level.
Radio Band Tune 1. Press to power on, then press SRC once or more to select tuner. FM2 FM3 2. P ress BAND once or more to select FM1 AM1 AM2. Display shows wave band, frequency, and preset station number if already stored. Radio tune by step manually: Press or less than 2 seconds. Radio seek automatically: Press or more than 2 seconds. Press either button to store the selected station. 05:59 AF REG FM: 104.
DVD & AV IN Mode Radio and Clock DVD Mode AMS : Auto Memory Store Press SRC button to select DVD mode (when disc is insert, and unit is reading disc), then press the DISP button. The LCD will display: Press AMS briefly to scan the preset station 1 - 6 for 5 seconds each. Hold more than 2 seconds, the 6 strongest available stations will be automatically saved in the memory of preset button 1 - 6. AF AF Clock Setting 1.
RDS ( Radio Data System ) RDS service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available. RDS Basics AF(Alternative Frequency): When the radio signal strength is poor, enabling the AF function will allow the unit to automatically search another station with the same PI (program identification) as the current station but with stronger signal strength.
RDS ( Radio Data System ) PTY Reception ( Program Type ) RDS FM stations provide a program type identification signal. Example: news, rock, info, sport, etc. PTY Mode: Press PTY to turn on the Program Type reception, the previous PTY type is shown. Press PTY once again to enter the MUSIC type o r press twice to enter the SPEECH type, then use buttons 1 - 6 to select the desired program type. The selected PTY type is shown and searching starts if no other function is selected for 2 seconds.
Disc Playback Disc Playable Disc Load / Eject File type supported Load: Press the slot. Eject: Press the disc. Audio file: MP3(*.mp3), WMA(*.wma) Video file: MP4(*.avi, DIVX3.11/4.0/5.0/6.0 /7.0) MPEG 2(*.vob) MPEG 1(*.dat) Picture file: JPEG(*.jpg) MP3 file: ISO 9660 or ISO 9660 + Joliet format - Max. 30 characters. Max. nested directory is 8 levels. The max. album number is 99. The max. length of each track is 99 minutes 59 seconds. S upported sampling frequency for MP3 disc: 8KHz to 48KHz (44.
Audio/Video/Picture File Playback When AUDIO/PICTURE/VIDEO file is played, Category/Folder/File list will be displayed on the screen, and file/folder name being played will be displayed on top. Current selected item will be highlighted. USB [ \ ]:MP3 SOND: FOLDER Category Select Use / to select AUDIO PICTURE VIDEO Press ENTER to confirm. Folder Select Use / to enter folder list and use press ENTER to confirm.
Track Playback Select desired track REPEAT - Press or to skip to the next track. - U se 1-9 and 0, 10+ buttons on the remote control to select desired track number. During playback, press RPT once or more. - RPT icon will appear on the display.
Track Playback PAUSE Program - During playback, press to pause playback. - The sound will be muted. - Display "PAUSE" in the TV screen, display and blink "PAUSE" on the panel display. Press again to continue playback. - Press PROG to enter program list. Use / or / cursor and digit button to enter number. For DVD and File disc, select title and chapter number. For VCD and CD, select track number. - Press to play, or move the cursor to select "PLAY" and press ENTER to play.
DVD Playback DVD Audio Select DVD Angle Select Press AUDIO or R/L to select audio language to listen if the DVD has multiple audio languages. Press ANGLE to select different angle to view if the DVD has multiple-angle views. ZOOM VCD Audio Select Press R/L to select audio channel to listen. Press ZOOM button, the picture will be zoomed accordingly. L R Stereo X2 DVD Subtitle Select Press SUB.T to select the subtitle language to show if the DVD has multiple language subtitles.
DVD Setup DVD System Setup Press SETUP to display setup menu on the screen. Use / to select setup items: TV System SYSTEM Use / SYSTEM , LANGUAGE / AUDIO VIDEO Select the TV system in the setting menu. DIGITAL to select and ENTER to confirm. LANGUAGE AUDIO VIDEO DIGITAL Screen Saver The screen saver appears if disc stop last more than 3 minutes. Original setting: ON. Video Output Mode Original setting: INTERLACE-YUV.
DVD System Setup Setting TV type Setting Rating The rating of the disc is from 1 to 8: (1) with the most limit when playing. (8) with the least limit when playing. Original setting: 8 Note: The rating can be selected only under the password unlocked status, and the limit can be worked only under the password locked status. Select TV type to watch wide screen movies. 4:3 Pan Scan: For 4:3 TV, left and right edges will be cut. 4:3 Letter Box: For 4:3 TV, black bars will appear on top and bottom.
DVD Language Setup OSD Language Subtitle Language Select on screen display language of the DVD . Select subtitle language of the DVD from which are contained in the DVD. HUNGARIAN CZECH HUNGARIAN CZECH Audio Language Menu Language Select audio language of the DVD from which are contained in the DVD. Select menu language of the DVD from which are contained in the DVD.
DVD Audio Setup Setting Volume Setup the volume with the / buttons.
DVD Video Setup Brightness Set the brightness of the video output with Set the contrast of the video output with Set the hue of the video output with Saturation . Set the saturation of the video output with Sharpness Contrast Hue / / / Set the sharpness of the video output with . . 26 / . / .
DVD Digital Setup Output Mode Dual Mono Select the output mode: LINE OUT: Compress the input signal. The volume is small. RF REMOD: The volume is large. Select the audio channel from STEREO, MONO L, MONO R and MIX MONO. Dynamic Range When you select the compressed mode as "line out", select it to adjust the compression proportion and get the different compressed effect. When select FULL, the audio signal is minimum; when select OFF, the audio signal is maximum.
Electrical Connections Wiring Diagram Video-out 1 Video-out 2 Video-in Antenna Camera-in USB slot (Blue) R(Red) L(White) (Pink) (Green/ White) (Yellow) (Yellow) (Yellow) (Yellow) (Black) Fuse 15A Subwoofer out Connector Aux-in Rear Line-out(Gray) R(Red) L(White) Reverse (Active high level input) Parking SW (Active low level input) ISO Connector 28 Amplifier
Electrical Connections Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. Cut the connector, connect the colored leads of the power cord to the car battery, as shown in the colour code table below for speaker and power cable connections.
Installation Guide Installation Procedures Important: First complete the electrical connections, and then check for correctness. Remove these two screws before installation. Otherwise, the DVD player will not work. Reset Press button to flip down the panel. Then press the RESET button with a pointed object to reset the unit to the original status. Note: Press the RESET button will erase the clock and stored stations. Mounting bolt rubber cushion.
Anti-Theft System This unit is equipped with a flip-down detachable panel. Panel can be detached and taken with you, helping to deter theft. Removing the panel 1. Press button to switch off the power of the unit. button to flip down the panel. 2. Press 3. Hold the right of the panel. Take off right end, and then take off the left end. 4. Place the panel into the case and take it with you when you leave the car. Install the panel 1.
Troubleshooting If you suspect something is wrong, immediately switch power off. Do not use the unit in abnormal condition, for example without sound, or with smoke or foul smell, can cause fire or electric shock. Immediately stop using it and call the store where you purchased it. Never try to repair the unit yourself because it is dangerous to do so. General Radio No power or no sound. Noise in broadcasts. Car's engine switch is not on. Turn your car's key to ACC or ON.
Specifications General Power supply Maximum power output Continuous power output Suitable speaker impedance Pre-Amp output voltage Fuse Dimensions(WxHxD) Weight Sub-out Aux-in level AM(MW) Radio 12 VDC(11 V-16 V) Test voltage 14.4V, negative ground 50 Wx4 channels 25 Wx4 channels (4 10% T.H.D.) 4-8 ohm 4.0 V(CD play mode: 1 KHz, 0 dB, 10 K load) 15A 178x50x166 mm 2.2 kg 4.
CLASS 1 LASER PRODUCT
