Operation Manual

21
Note : Use only the contents of this package to install and use t he system.
Using accessories not provided with this player may damage the player.
Mounting and Wiring precautions
z This unit is exclusively for vehicles with a negative ground, 12V power
supply.
z This unit may be installed with additional mobile audio components, such
as a digital camera.
z Always use great care when attaching anything to a vehicle. Check
clearances on both sides of the planned installation before drilling any
holes or installing any screws.
z A good chassis ground connection is critical to minimize resistance and
avoid noise problems. Use the shortest wire possible and securely
connect it to the car chassis.
z When routing RCA cables, keep them away from the power cables and
output speaker wires, engine, exhaust system, ect. Heat may damage
wires.
z If the fuse should blow, make sure that all connections are correct, the
cables have not caused a short circuit, and no wires are damaged. Then
replace the fuse with a new fuse of the s ame amperage value as the
original fuse. When replacing a fuse, never let the power cable touch any
metal part or other wire.
z Never let disconnected cables or terminals touch metal on the car or any
other conducting material.
z To prevent short circuit, do not remove the caps from unused terminals or
from the ends of unconnected cables.
z Insulate unconnected wires with vinyl tape or other similar material.
W
arning!
To prevent short circuits during installation, disconnect the vehicle’s negative
battery lead before making any power connections.
Installation procedure
1. Screw the Installation Bracket to the beam or plywood using the ST4.2x16
screws.
2.
Installing the trim ring on the player using the TB 2.6x6 screws .
3. Plug in power harness and audio/video source cablesinto the overhead
monitor .
4.
Attach the player to the Installation Bracket using the PM4x8 .
5. Check the car’s brake lights, blinkers, wiper, etc. to ensure they are
working property