MULTIMEDIA RECEIVER INSTRUCTION MANUALS
CONTENTS Be sure the temperature inside the vehicle is between +60℃ and -10℃ before turning on your unit. PRECAUTION........................................................ 2 SPECIFICATION SPECIFICATION .................................................... 2 FRONT PANEL .......................................................3 GENERAL DC 12 Volts, REMOTE CONTROL .............................................. 4 Power Supply Requirements Negative Ground BLUETOOTH OPERATION ............................
FRONT PANEL 1. Rotate the volume control to change the setting of these Press this button to switch on the unit. When the system is on, functions. press this button to shut off the sound output and press again In radio mode, press and hold to enter system setup. to resume. Press I<< / >>I button to select the BEEP, CLO ADJ , CLO When the system is on, press and hold this button to turn off MODE, RADIO AREA and TFT BRIGHT settings and press the unit. VOL button to confirm. 2/9.
13. MIC 7. NUMBER BUTTONS 14. TFT display NUMERALS 1-6 (in radio mode) 15. SD Card slot Press the keys to select a preset station directly. Insert SD card, it will play the files of SD card automatically. Press and hold the keys to store the current station in preset Note: Once the SD cards could not eject after pressing, just memory band. take it out manually. 3/RPT: In playback mode, press to repeat playing. 16. USB insert slot 4/RDM: Press to play the songs in random order.
BLUETOOTH OPERATION 14. ST In radio mode, press this button to switch output mode between STEREO and MONO. 1. LINKING In bluetooth mode, press the green button to dial up Press on MODE button to switch to bluetooth mode. a call or receive a coming call; Turn on the bluetooth function on the cell phone and 15. LOUD: Press this button to function LOUD on/off. start to search the device named KSC3001. 17. V-, SEL, V+ The linking is finished after entering the pass number 1234.
PICTURE VIEWING MP4/MP5 OPERATION Picture viewing LOADING AN MP4/MP5 FILE In picture viewing mode, press F+/F- button on the remote Insert a USB/SD with audio and/or video files, the unit control OR ▲/▼ button on the panel to rotate the picture supports files with following formats. clockwise/counterclockwise 90 °. 1. Audio formats: MP3, WMA, APE, OGG, FLAC, and Note: It is not available in automatic viewing mode. WAV. 2. Picture format: JPEG, BMP. Automatic/manual viewing a picture 3.
INSTALLATION REAR-MOUNT Installation using the screw holes on the sides of the unit. INSTALLATION PROCEDURES First complete the electrical connections, and then check them for correctness. INSTALLATION OF THE UNIT Remove the outer rim around the front panel and the side springs. Select a position where the screw holes of the mounting 1. Metal Sleeve bracket and the screw holes of the radio become aligned and Install the metal sleeve in the dashboard. tighten the screws at 2 places on each side.
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to ACC. No sound. Sound skips. The operation keys do not work. The fuse is blown. Replace the fuse. Volume is in minimum. Adjust volume to a desired level.
The BLUETOOTH ® world mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by ALDINET S.p.A. is under license. The MACROM brand is a registered trade mark of MACROM SA and any use of such marks by ALDINET S.p.A. is under license.
