MULTIMEDIA RECEIVER INSTRUCTION MANUALS
CONTENTS SPECIFICATION PRECAUTION........................................................ 2 GENERAL DC 12 Volts, SPECIFICATION .................................................... 2 Power Supply Requirements Negative Ground FRONT PANEL ....................................................... 3 Chassis Dimensions 178x 92x 50 mm REMOTE CONTROL .............................................. 4 Bass (at 100 Hz) + 10 dB / 10 dB MP4/MP5 OPERATION ..........................................
FRONT PANEL 1. In BEEP mode, press the I<< / >>I button to select turn ON Press this button to switch on the unit. When the system is on, the BEEP function, press again to resume. press this button to shut off the sound output and press again In CLO ADJ mode, press I<< / >>I button to start the hour to resume. setting or minute setting. When the system is on, press and hold this button to turn off In CLO MODE mode, press I<< / >>I button to select 12H the unit. or 24 H mode. 2/9.
6 / F+ REMOTE CONTROL Press the button to go to the 10+ song. (when an MP3 / WMA is being played). A Picture viewing can be rotated by pressing the button. 7/LOC Press this button to select a strong or weak radio reception. 8/BAND Press this button to switch between the radio bands available. 9/AMS Press this button to scan the preset stations. Press and hold: To store the station into the memory in the 1. descending order of the instantaneous signal strength.
PICTURE VIEWING MP4/MP5 OPERATION Picture viewing LOADING AN MP4/MP5 FILE In picture viewing mode, press F+/F- button on the remote Insert a USB/SD with audio and/or video files, the unit control OR ▲/▼ button on the panel to rotate the picture supports files with following formats. clockwise/counterclockwise 90 °. 1. Audio formats: MP3, WMA, APE, OGG, FLAC, and Note: It is not available in automatic viewing mode. WAV. 2. Picture format: JPEG, BMP. Automatic/manual viewing a picture 3.
INSTALLATION REAR-MOUNT Installation using the screw holes on the sides of the unit. INSTALLATION PROCEDURES First complete the electrical connections, and then check them for correctness. INSTALLATION OF THE UNIT Remove the outer rim around the front panel and the side springs. Select a position where the screw holes of the mounting 1. Metal Sleeve bracket and the screw holes of the radio become aligned and Install the metal sleeve in the dashboard. tighten the screws at 2 places on each side.
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to ACC. No sound. Sound skips. The operation keys do not work. The fuse is blown. Replace the fuse. Volume is in minimum. Adjust volume to a desired level.
The MACROM brand is a registered trade mark of MACROM SA and any use of such marks by ALDINET S.p.A. is under license.
