Installation manual

Page 23

For Pole-Mounted Applications

Fig 15

A) Cut and mount bracketing.

i) Cut and assemble UniStrut or equivalent bracketing (not included). Use the

mount assembly as a template for length and hole spacing.

ii) Securely attach the brackets to the pole at the desired height. Be sure that all

strap bolts are firmly tightened and that the vertical spacing is correct.

B) Attach the fan to the bracketing.

i) Insert 1/2" bolts with 1 washer each into the brackets.

ii) Slide the mount assembly over the bolts and attach using nylon lock nuts and flat

washers.

Step 2, Attach Motor Assembly To Mounting Assembly

Place the motor assembly on the mounting assembly, making sure the mount assembly pivot section

is flat.

Rotate the motor assembly to approximately the desired horizontal angle. Make sure to leave enough

room to use at least three (3) mounting bolts to attach the motor assembly

to the mounting assembly.

Insert supplied 1/2" mounting bolts and washers downward through holes. Securely

tighten the provided nylon lock nuts, using washers to maximize hold. Four mount bolts are best, but

at least three (3) mounting bolts must be used.

Step 3, Make Control And Motor Cable Connections

For variable-speed fans, set up the Motor Control Panel and Remote Switchbox

according to the instructions found in Step 4 through Step 7 of the regular instructions (pages 12

through 15).

For single-speed fans, wire up the included circuit breaker/starter according to the instructions

printed on the inside of the box.

MacroAir, Inc. www.macroairfans.com Toll Free: 866-668-3247 Build: March 2012