User's Manual

Ma c r o I ma ge Te c h n o l ogy
MyHD
Ma c r o I ma ge Te c h n o l ogy
MyHD
Installation of MyHD board in a PC
5 6
MyHD Hardware InstallationMyHD Hardware Installation MyHD Hardware InstallationMyHD Hardware Installation
1. With the power off, remove your computer
cover and locate an available PCI slot.
2. Remove the screw attached to the slot cover and remove the slot cover plate.
3. Before handling the MyHD card, ground yourself by touching the power supply box
inside your computer
4. Position your card directly above the PCI slot and insert the card firmly into the slot. Care
should be taken to press it evenly and snugly into its slot.
To install the MyHD board, follow the steps listed below:
 Warning - Static Sensitive Components
To avoid possible damage to MyHD Board and/or other system components from static
discharge, always discharge your body’s static electricity prior to handling MyHD Board
or other system components.
Discharging can be done either by using a properly grounded anti-static wrist strap or by
simply touching the chassis of a grounded (plugged-in) computer. In addition, always
handle the card by its edges whenever possible, to avoid mechanical damage to delicate
components on the board.
5. Use the enclosed audio jumper cable to connect
the audio output of the MyHD card to the LINE IN,
AUX or CD input of your PC sound card or
motherboard.
**If the audio output is set by the jumper cable in the
MyHD application program, you have to connect the
jumper cable between the MyHD card and a sound
card. However, you do not need to do it when the
audio output is set by wave in the MyHD application
program.(Refer to “Audio Configuration on page 37 ).
6. Replace the cover on the computer.
7. Attach the antenna lead from your rooftop antenna or cable system to the antenna input
of the MyHD card.
Rooftop
Antenna
Cable