Instruction manual

13
 Cameras
Connect the camera video input connectors to the video outputs from system cameras or
other composite video sources via coaxial cables.
 Main monitor
Connect the main monitor output connector (BNC) to a surveillance CCTV monitor.
The CCTV monitor displays selected live or recorded cameras in any available split
window format.
 Hard disk drive(s)
Make sure to install at least one hard disk drive inside the hard disk tray.
Note: Each of the HDDs must be formatted before it can be used to record
video/audio. Please refer to Section 6.6.1 HDD Format/Clear to format the
HDDs.
Before connection After connection
 Power
Plug 115 VAC or 230 VAC power source into the power socket.
3.2 Optional Connections
 Audio inputs
Connect the audio input connectors to the audio line-outs from system cameras or other
audio sources. Please make sure to associate the audio inputs with the cameras in Camera
Setup as described in Section 6.2 accordingly.
 Audio outputs
Connect the audio output connectors to the audio line-ins from speakers.

Alarm inputs
Each alarm input should have 2 or 3 wires. Those with 2 wires will either be Normally
Open (NO) or Normally Closed (NC). Those with 3 wires will allow the user to
choose. Connect two of those wires to the alarm input connector in the pairs. Direction
does not matter. There is availability for 16 possible alarm inputs. When the alarm input
has been connected, please configure the software system accordingly as per Alarm Setup
as described in Section 6.3.