Installation guide

44
 WAP Picture Quality – the WAP picture quality if WAP access is supported for the DVR.
Press +/- buttons to change the value.
 IP Filter #1-4 – the IP filters #1-4 for remote access. Only those PCs with IP addresses
matching one of the IP filters can access the DVR remotely.
NOTE：
：：
：
If the Control Port or Data Port is not available or accessible during remote access, the system
will reset the ports to their default values, i.e. 67/68.
Factory Default:
The DVR can repeat to get the factory default figures through this function. Press the
“Direction Control” button to reset the DVR to factory default figure. You also can use the
mouse to do it.
NOTE：
：：
：
When you want to reset the default setting, the DVR will pop-up the confirmation window to
check again with customer.