Installation guide

19. Network:

In SETUP SETTING Mode, press Direct Control button to change the highlighted option to

Network, and then press ENTER to call up Network Setup as shown.

The Network Setup allows the administrator to setup all Ethernet network related parameters.

Please check with your network administrator to set these parameters correctly.

The general operations are as below:

Direct Control

Press these buttons to select the items.

MENU/ESC

Press this button to escape from this screen, and return to Setup Menu display. If the Save

dialog is shown, press ENTER to exit and save, MENU/ESC to exit without saving.

Following is a brief description for each item and its specific operations:

 Net Type – Static IP, PPPoE, or DHCP. DHCP can only be used for intranet (LAN) access,

while Static IP and PPPoE can be used for both internet & intranet access. Press +/-

buttons to change the Net Type.

 IP Address – Ethernet IP address for the system. To get the static IP address, please

contact your local ISP (Internet Service Provider).