User manual

Taurus S2 User Guide
If the system
necting
e interface cable
r connect the
device before
booting your
Operating System.
the drives have been pre-installed and setup already, you do
Connect the Taurus and turn it on.
ormatting”.
a is
Otherwise, an
error message will appear.
doesn’t recognise
the drive, turn on
the power first,
before con
th
o
Installation on a PC
Before connecting the device, setup the RAID mode using the
selector switch at the back of the enclosure.
If
not need to change anything, unless you prefer a different
setup.
• Turn on your Computer and start Windows.
•
• Let Windows search and install the driver automatically.
• Open “My Computer” to see your external hard drive.
Note: For more info about formatting, see “Partitioning &
F
Remove Procedure
For the safe removal of your drive and to assure that no dat
lost, always follow the correct unplug procedure.
• Click on the taskbar icon for external hardware
• Choose your external hard drive and confirm to remove it
Page 9 / Chapter 3 - System Set Up