User manual

Driver Upgrade
It is recommended that all users use the same driver revision.
Before upgrading the driver, please follow these guidelines:
• If possible, first backup all your data.
• Disable all NDAS devices.
• Uninstall the present driver.
• Install the new driver.
• Register the NDAS devices again.
• Mount the NDAS devices.
• You should now be able to use the NDAS devices again.
PC Command Line Utility
For advanced users on a PC, there is an option to run the
NDAS software from a command line interface.
• Open the command line and type following:
cd C:\Program Files\NDAS\System
(Folder may vary depending on driver being used)
• Type ndascmd.exe, which will load the command line
interface for the NDAS software
The Syntax for the interface should be as follows:
ndascmd <command> [parameters]
The supported commands are following:
• register <name> <device id without dash> [write key]
• unregister <device number>
• list devices
• list logicaldevices
• mount <logical device number> [ro|rw]
• unplug <logical device number>
• unmount <logical device number>
• activate <device number>
• deactivate <device number>
- 15 -