User manual

Page 2 / Chapter 1 - Introduction
USER MANUAL
M9-SATA USB/LAN
1.4 System Requirements
1.4.1 PC Requirements
• Minimum Intel Processor III 500MHz, 128MB RAM
• USB 2.0 (USB 1.1) equipped PC; Windows 2000/XP/Vista
• 10, 100 or 10/100Mbps fast Ethernet card, or a USB-to-
Ethernet converter equipped PC; Windows 2000/XP/Vista
1.4.2 Mac Requirements
• Minimum Apple G4 processor, 128MB RAM
• USB 2.0 (USB 1.1) equipped Mac; Mac OS 10.2 or above
• 10, 100 or 10/100Mbps fast Ethernet card, or a USB-to-
Ethernet converter equipped Mac; Mac OS 10.2 or above
If you forgot the
login, press and
hold the reset
button, turn on the
device and wait for
the LED to stop
blinking (~30 sec).
Release the button
and reboot the LAN
disk. This will reset
the device to its
factory default
settings.
1.5 Detailed View
Front LED status lights:
= HDD access
= Network status
OS = System status
X Y Z [ \ ]
Fan settings:
A = Auto
M = Manual
H = High speed
L = Low speed
1. Power switch
Ensure the thermal
probe is attached to
your drive, when
using the Auto
mode for the fan
speed.
2. Power receptacle
3. Fan mode switch
4. 10/100 Ethernet port
5. Reset button
6. USB 2.0 port