User manual

USER MANUAL
M9-SATA USB/LAN
It is recommended
to periodically
check the website
of your vendor for
possible updates.
If you modify the
partitions or file
ystem when the
ted
and only if
’s formatted using
the FAT32 file
system.
If the disk
information shows
that the drive has
not been found, use
the disk utility to
format it again.
r
s.
ork Information: Displays the current IP address and
the MAC address of your network drive.
order not to interfere
our
sses or in a company, a
dedicated DHCP server might already be running.
When the network drive is connected directly to your
computer via patch cable but without a router, the DHCP
server will be turned on. This will allow you to connect to the
or
s
• Disk Information: Displays details about the installed hard
drive and the capacity.
If you do not see any details, it is possible that the drive has
not yet been installed or it has not been recognised because
it has not yet been formatted. Make sure the hard drive has
been installed properly and then use the disk utility to format
it.
s
drive is connec
via USB, keep in
mind that the LAN
disk is only able to
access the first
partition
it
• Firmware Version: Displays the current firmware and loade
version. Check your vendor’s website for possible update
• Netw
The DHCP server should be disabled in
with your existing DHCP server. In most circumstances, y
router will be assigning the IP addre
network drive without crossover cable.
• Service Information: By default, both Samba and FTP
services are enabled, allowing you to transfer files via FTP
mount the network drive using SMB.
If you only use one of these services, we recommend
disabling the other one for security reasons. You can alway
enable it again in the future.
Page 14 / Chapter 4 - LAN Disk Setup