User manual

USER MANUAL
M9-SATA USB/LAN
The IP address as
seen in the screen
captures is for
reference only. Your
IP address will most
likely be different.
To reset the device,
to its factory default
settings, press and
hold the reset
button, turn on the
power and wait for
the LED to stop
blinking (~30 sec).
Release the button
and reboot the LAN
disk.
If you connect the
LAN disk to your
computer directly,
make sure to obtain
the IP address and
DNS settings
automatically,
otherwise you may
not be able to find
the device.
5. Open your web browser and enter the IP address from the
previous step to access the web configuration interface.
6. Press the Enter key and you will be asked for the username
and password to login.
Default Login
Username: admin
Password: admin
Note: We strongly suggest you to change the password as
soon as you are logged in, to prevent unauthorized access.
4.1.4 Peer to Peer
If you connect the network drive directly to your computer via
Ethernet cable, you can access it using its default IP
169.254.0.1. Open the web browser and enter 169.254.0.1 to
access the configuration page.
Note: You can use the standard patch cable that has been
included with your product. There is no need for a crossover
cable because the DHCP server of the network drive will turn
on automatically.
Page 11 / Chapter 4 - LAN Disk Setup