User manual

Taurus - RAID User Guide
The aluminium
stand does not
have to be removed
for drive assembly.
For RAID 0 and
RAID 1, identical
hard drives are
recommended
(same manufacturer,
capacity and RPM)
Do not bend the
thermal sensor!
Taurus RAID II
1. Remove the four screws at the bottom of the case.
2. Push the inner enclosure out, and remove the outer chassis.
3. Install the first hard drive and mount it with two screws on
each side.
4. Attach the thermal probe with the tape provided to the first
HDD. Choose a place in between the two drives but without
damaging the probe when installing the second drive.
Page 7 / Chapter 2 - HDD Assembly