Product Overview

THERMOSTATIC OPERATOR
DIRECT MOUNT w/Remote Sensor
EVO-Z
Tunstall Corporation
118 Exchange Street • Chicopee, MA 01013
© July 2015
We reserve the right to alter designs, specifications and information without notice.
Phone [phone] · Fax [phone]
www.tunstall-inc.com • www.maconcontrols.com
Bulletin-MC-EVO-Z-1015
Section: Non-Electric Operators
Maximum & Minimum Setting
Maximum setting
1. Turn the wheel to maximum.
2. Push the mark in with limit tool (located opposite the dial setting window) and press in the wheel
handle 1-2 mm until it stops. (Figure 1)
3. Remove the limit tool and press in the wheel handle until it stops. (Figure 2)
4. Set the required temperature according to the chart below.
5. Pull the wheel handle out and the maximum temperature is set. (Figure 3)
Minimum setting
1. Turn the wheel to minimum
2. Push the mark in with limit tool (located opposite the dial setting window) and press in the wheel
handle 1-2 mm until it stops.
3. Remove the limit tool and press in the wheel handle until it stops.
4. Set the required temperature according to the chart below.
5. Pull the wheel handle out and the minimum temperature is set.
NON-ELECTRIC
OPERATORS
DIAL SETTINGS
0 * 1 3 5 6 7 8 9
Off 50 54 61 68 72 75 79 82
Frost
Protection
Figure 1 Figure 2
Figure 3
Mark
Wheel