Brochure

Phone [phone] · Fax [phone]
www.tunstall-inc.com • www.maconcontrols.com
Bulletin-MC-RCM-1014
Electric Operators
Tunstall Corporation
118 Exchange Street • Chicopee, MA 01013
© July 2014
We reserve the right to alter designs, specifications and information without notice.
Remote Control Module - MAC-RCM
16
Registering the MAC-RCM on MAC-WSA wireless small actuator wireless partners
NOTICE
This product description describes specific settings and functions of the MAC-RCM . In addition to these instruc-
tions, the product descriptions of other system components, such as wireless partners, are to be observed.
► Before beginning the registration process, check for the wireless icon on the display of the MAC-RCM
to determine if a wireless partner is already register ed. If so, delete it (see section “Deleting wireless partners”).
► Press the knob for 2 s.
► Use the knob to select the “Service level” function SR.
► Press the knob.
► Use the knob to select the “Register weekly schedule” function W.
► Press the knob.
Indicator A flashes.
► Press the knob.
The wireless icon flashes.
► Trigger a registration radiogram on the MAC-WSA Details can be found in the
documentation of the wireless partner.
Data such as device ID, setpoint, etc. are exchanged via radiogram.
■ If the registration process is successful, the wireless icon will be continuously displayed
and the MAC-WSA wireless small actuator confirms this visually (status LED lights up for
approx. 2 s) and acoustically (beeping tone sounds twice).
■ Up to 4 MAC-WSA wireless small actuators can be registered simultaneously.
All wireless small actuators must be registered during a registration process.
Adding a further wireless small actuator is not possible afterwards.
NOTE
After a successful registration, the device ID of the wireless partner is permanently stored in the SolarFunk room
control module. The registration process does not need to be performed again when the internal energy storage is
changed.
■ If the registration process fails, the wireless icon is no longer visible on the display.
► The registration process must be performed again, or you must check the wireless
path. See chapter “General installation instructions”, page 5.