Installation Guide
C. Installing mac LEDS POP flat LO fixture
D. Installing the Hard Wired Power Supply
If you wish to hard wire the power supply direct to the AC mains, have a qualified electrician connect the line voltage to the
input side of the power supply in accordance with national, state and local electrical codes using an appropriate junction box
(not included).
1) Isolate from the mains supply before installation
2) Wire the LED fixture onto the DC output of the driver using the pigtail.
RED= positive
BLACK= negative
3) Wire the input to AC 120 line/mains
WHITE- neutral
BLACK= line or hot
OR
BLUE= neutral
BROWN= line or hot
4) A standard TRIAC dimmer may be used on the AC/line side if a dimmable driver has been used.
Limited Warranty
Mac LEDS (the “Manufacturer”) warrants to the original buyer, with proof of purchase, (the “Buyer”) that each product manufactured and sold
by Manufacturer (the “Product”) will be free from defects in the material and workmanship in its intended use (normal wear and tear
excepted).This warranty covers Manufacturer’s LED components operated on Manufacturer power supplies for a period of THREE YEARS from
(the invoice date) from Manufacturer. This warranty does not cover damage caused by tampering with or unauthorized use of or abnormal
stress of the product. Unauthorized use or abnormal use or stress includes operation or use of the product in an operating environment that
exceeds the limitations specified in the Manufacturer’s specifications. This warranty applies to the Buyer. If you have any questions or
concerns, please contact mac LEDS:
www.macleds.com info@macleds.com
P) 888.908.3521
F) 585.672.6134