Specifications
DigiRack Plug-ins Guide52
LPF (Low-Pass Filter) Controls the cutoff fre-
quency of the Low-Pass Filter. Use the LPF set-
ting to attenuate the high frequency content of
the feedback signal. The lower the setting, the
more high frequencies are attenuated. The max-
imum value for LPF is Off. This lets the signal
pass through without limiting the bandwidth of
the plug-in.
Delay Sets the delay time between the original
signal and the delayed signal.
Depth Controls the depth of the modulation ap-
plied to the delayed signal.
Rate Controls the rate of modulation of the de-
layed signal.
Feedback Controls the amount of feedback ap-
plied from the output of the delay back into its
input. It also controls the number of repetitions
of the delayed signal. Negative feedback settings
give a more intense “tunnel-like” sound to
flanging effects.
Tempo Sync Provides a direct connection be-
tween the Pro Tools session tempo and plug-in
controls that support MIDI Beat Clock (such as
Delay). This direct connection lets plug-in pa-
rameters such as delay, automatically synchro-
nize to, and follow changes in, session tempo.
When Tempo Sync is enabled, the Tempo and
Meter controls are uneditable and follow the ses-
sion tempo and meter changes. The Duration
and Groove controls apply when Tempo Sync is
enabled.
To enable Tempo Sync:
Click the Tempo Sync icon. The tempo shown
changes to match the current session tempo and
the meter changes to match the current meter.
Tempo Selects the desired tempo in beats per
minute (bpm). This setting is independent of
Pro Tools’ tempo. When a specific Duration is
selected (see “Duration” below), moving this
control affects the Delay setting. Likewise, the
range of both controls will be limited to the
maximum available delay with the currently se-
lected Duration. To enter very short or long de-
lays it may be necessary to deselect all Duration
buttons.
When Tempo Sync is enabled, the Tempo con-
trol is unavailable.
Meter Use this to enter either simple or com-
pound time signatures. The Meter control de-
faults to a 4/4 time signature.
When Tempo Sync is enabled, the Meter control
is unavailable.
Tempo Sync icon
Tempo Sync