Specifications

DigiRack Plug-ins Guide20
Input and Output Meters
The Input (In) and Output (Out) meters show
peak signal levels before and after dynamics pro-
cessing:
Green Indicates nominal levels.
Yellow Indicates pre-clipping levels, starting at
–6 dB below full scale.
Red Indicates full scale levels (clipping).
The clip indicators at the top of the Output
meters indicate clipping at the input or output
stage of the plug-in. Clip indicators can be
cleared by clicking the indicator.
Toggling Multichannel Input and Output Meters
With multichannel track types LCRS and
higher, both Input and Output meters cannot
be shown at the same time. Click either the In-
put or Output button to display the appropriate
level meter. The Input/Output meters display is
toggled to Output by default.
Gain Reduction Meter
The Gain Reduction (GR) meter indicates the
amount the input signal is attenuated (in dB)
and shows different colors during dynamics pro-
cessing:
Light Orange Indicates that gain reduction is
within the “knee” and has not reached the full
ratio of compression.
Dark Orange Indicates that gain reduction is be-
ing applied at the full ratio (for example, 2:1).
Threshold Arrow
The orange Threshold arrow next to the Input
meter indicates the current threshold, and can
be dragged up or down to adjust the threshold.
When a multichannel instance of the plug-in
has been configured to show only the Output
meter, the Threshold arrow is not displayed.
Phase Invert
The Phase Invert button inverts the phase (po-
larity) of the input signal, to help compensate
for phase anomalies that can occur either in
multi-microphone environments or because of
mis-wired balanced connections.
The Input and Output meters display differ-
ently depending on the type of track (mono,
stereo, or multichannel) on which the plug-
in has been inserted.
When Side-Chain Listen is enabled, the
Output meter only displays the levels of the
side-chain signal. See “Side-Chain Listen”
on page 31.
Input and Output meter buttons
Input and
Output Meter
buttons