Specifications

Chapter 3: DigiRack D-Fx Plug-ins 7
chapter 3
DigiRack D-Fx Plug-ins
(AudioSuite Only)
D-Fx provides four modules:
•Chorus
•Flanger
•Multi-Tap Delay
• Pin-Pong Delay
Chorus
(AudioSuite Only)
Chorus adds a shimmering quality to audio ma-
terial by combining a time-delayed, pitch-
shifted copy of an audio signal with itself.
Gain Adjusts the input volume of the chorus to
prevent clipping or increase the level of the pro-
cessed signal. This slider is set to a default of
+3 dB. If your source audio has been recorded
very close to peak level, this +3 dB default set-
ting could cause clipping. Use this control to re-
duce the input level.
Selecting the Sum Inputs button sums the dry
input signals (mono or stereo) before processing
them. The dry signal then appears in the center
of the stereo field and the wet, effected signal
will be output in stereo.
When the Sum Inputs button is selected, the
LFO waveform on the right channel is automat-
ically phase inverted to enhance the mono-ste-
reo effect.
Mix Adjusts the balance between the effected
signal and the original signal and controls the
depth of the effect. Mix is adjustable from 0% to
100%.
Low-Pass Filter Controls the cutoff frequency of
the Low-Pass Filter. Use this to attenuate the
high frequency content of the feedback signal.
The lower the setting, the more high frequencies
are removed from the feedback signal.
Chorus plug-in
The Chorus plug-in was formerly called
D-fx Chorus. It is fully compatible with all
settings and presets created for D-fx Chorus.
Sum Inputs button