User's Manual

19
Owner’s Manual
Owner’s Manual
Aux Masters and Internal FX
THEREMIN
FREQUENCY AMPLITUDE
100
50
0HIGHLOW
40
41 42
43
44
45
42. Preset Selector
Rotate this endless control to select one of the 24
preset eects. When the rotation stops, that preset
number will flash for 0 seconds. Push the control
in prior to that in order to select the preset or let
it revert back to the previously selected preset.
The current preset number is shown in the display.
The dierent presets are shown in the table below
and on the mixer’s silkscreen near the main meters.
Further details of each preset are explained in Appendix
C on page 40. Only one preset may be selected at
a time.
43. Preset Display
This display shows the number of the currently
selected eects preset, as shown in the list of presets
above. Rotate the preset selector knob right or lef
to change a preset. When the mixer is turned on,
the FX section will load up the last-used preset.
44. FX Mute Switch and LED
When engaged, the internal eects processor
is muted, and its output will not appear on the main mix
or monitor mix. The adjacent mute LED will illuminate
as a reminder that the eects are muted. When power
is first applied to the mixer, this LED will illuminate
and the FX will be muted for about 5 seconds while
the little FX gerbils inside settle down.
If this switch is not engaged, then the internal eects
are set free and may be added as required to the main
mix and/or monitor mix.
If this switch is not engaged, then the internal
eects may be muted or un-muted with a footswitch
[all ProFXv3 mixers except the ProFX6v3].
 Bright Room 3 Doubler
2 Warm Lounge 4 Echo
3 Small Stage 5 Delay  (Fast)
4 Warm Theater 6 Delay 2 (Medium)
5 Warm Hall 7 Delay 3 (Slow)
6 Concert Hall 8 Ping-Pong Delay
7 Cathedral 9 Overdrive / Distortion
8 Small Plate 20 Spring Reverb
9 Large Plate 2 Early Reflections
0 Chorus  22 Auto-Wah
 Chorus 2 23 Flange
2 Delay + Reverb 24 Slapback Reverb
40. Aux Master Knobs
[ProFX2v3, ProFX6v3,
ProFX22v3, ProFX30v3]
These provide overall control over the aux mon
and aux FX levels just before they are delivered
to the aux mon and aux FX outputs, as well
as internal FX in the case of the FX master.
Auxiliary is usually the control you turn up when
the lead singer glares at you, points at his stage
monitor, and sticks his thumb up in the air. (It would
follow that if the singer stuck his thumb down, you’d
turn the knob down, but that never happens.)
The ProFX2v3 has a single aux master
and no aux FX master.
4. FX to Mon Knobs
[ProFX2v3, ProFX6v3,
ProFX22v3, ProFX30v3]
These knobs route the eects output to the monitors.
Use the mon controls to provide eects to monitors.
Slowly add eects to the monitors by turning the mon
knobs clockwise. Use the aux master knobs (described
above) to monitor the amount sent.
The ProFX2v3 has a single FX to mon knob.