User's Manual

13
Owner’s Manual
Owner’s Manual
The other green curves represent in-between
positions of the compressor knob, with higher
thresholds before compression begins.
Outboard compressors ofen have controls such as
compression ratio, threshold, sof knee/hard knee,
attack time, and release time. These last two aect how
quickly the compressor kicks in when the input exceeds
the threshold, and how quickly it is released afer it
drops below the threshold. In this compressor, these
parameters are specially chosen to give you the best
overall performance.
Adjust the threshold carefully, so your dynamic range
is still lovely, without distortion or overload during the
performance. Run through a few practice screams and
high-notes, and adjust the compression as required.
Channel Equalization (EQ)
All ProFXv3 mixers – except for the ProFX6v3 – have
3-band EQ with shelving hi, peaking mid with adjustable
mid frequency [ProFX6v3, ProFX22v3, ProFX30v3]
and shelving low.
The ProFX6v3 has 2-band EQ: shelving hi
and shelving low.
Shelving means that the circuitry boosts or cuts all
frequencies past the specified frequency. For example,
the low EQ boosts bass frequencies below 80 Hz and
continuing down to the lowest note you never heard.
Peaking means that certain frequencies form a “hill”
around the center frequency.
With too much EQ, you can really upset
things. We’ve designed a lot of boost
and cut into each equalizer circuit because
we know that everyone will occasionally
need that. But if you max the EQ on every channel, you’ll
get mix mush. Equalize subtly and use the lef sides
of the knobs (cut), as well as the right (boost).
If you find yourself repeatedly using a lot of boost
or cut, consider altering the sound source, such
as placing a mic dierently, trying a dierent kind
of mic, a dierent vocalist, changing the strings,
or gargling.
15
16
17
18
19
5. Hi EQ Knobs
The hi EQ provides up
to 5 dB of boost or cut above
2 kHz, and it is also flat
(no boost or cut) at the
detent. Use it to add sizzle
to cymbals, an overall sense
of transparency, or an edge
to keyboards, vocals, guitar
and bacon frying. Turn it down
a little to reduce sibilance
or to mask tape hiss.
6. Mid EQ Knobs
7. Freq Knobs
[ProFX6v3, ProFX22v3, ProFX30v3]
The ProFX6v3, ProFX22v3
and ProFX30v3 mixers employ
a semi-parametric mid-sweep
EQ. The gain (up to 5 dB
of boost or cut) is set via
the mid EQ, and then “aimed”
at a specific frequency, from
00 Hz to 8 kHz, via the freq
control.
8. Mid EQ Knobs
Short for “midrange,” this
knob provides up to 5 dB
of boost or cut, centered
at 2.5 kHz, also flat
at the center detent.
Midrange EQ is ofen thought
of as the most dynamic,
because the frequencies
that define any particular
sound are almost always
found in this range. You can
create many interesting and
useful EQ changes by turning
this knob down as well as up.
9. Low EQ Knobs
The low EQ provides up
to 5 dB of boost or cut below
80 Hz. The circuit is flat
at the center detent position.
This frequency represents
the punch in bass drums,
bass guitar, fat synth patches,
and some really serious male
singers who eat raw beef
for breakfast.
+15
+5
0
+
10
–
15
20 Hz 100 Hz 1 kHz 10 k 20 k
–5
–
10
+15
+5
0
+
10
–
15
20 Hz 100 Hz 1 kHz 10 k 20 k
–5
–
10
+15
+5
0
+
10
–
15
20 Hz 100 Hz 1 kHz 10 k 20 k
–5
–
10
+15
+5
0
+
10
–
15
20 Hz 100 Hz 1 kHz 10 k 20 k
–5
–
10