User's Manual
Table Of Contents
- Important Safety Instructions
- Contents
- Introduction
- Software User's Guide
- Changing Modes
- Installation
- VESA / Omnimount Mounting
- Hookup Diagrams
- Front Panel
- Rear Panel
- Appendix A: Key Commands
- Appendix B: Fader Alignment
- Appendix C: Software Support
- Appendix D: Service Information
- Appendix E: Technical Information
- Mackie Limited Warranty
10
Mackie Control Universal
Mackie Control Universal
Appendix A: Key Commands
Engaging certain switches on the MCU Pro and MCU XT Pro during power up perform a variety of
configuration tasks. See the table below for more information.
Key Command Function More Information
Mode Change Select 1 and 2 Page 4 and Appendix C
Fader Alignment V-Pot 1 and 2 Appendix B, page 11
Upgrade Firmware Record 1 and 2 plus Select 1 See firmware update release notes