User`s guide

User’s Guide
10
Final Mix for Tracktion
EQ Editing on the graph
Six nodes are displayed on the Pre or Post EQ
curve currently selected for editing. Each node
on a selected curve offers independent gain,
frequency and Q control. To adjust EQ curves,
simply drag individual nodes by grabbing a ball
with your mouse as follows:
Frequency change: Left-click and
move left or right
Gain change: Left-click and
move up or down
Q change: Right-click and
move left or right
Set to default: Control-click
EQ Values Panel
Double-clicking anywhere on the EQ screen
background brings up the EQ Values panel.
EQ Values panel
This shows the gain, frequency and Q values
corresponding to either the Pre or Post EQ.
What is shown depends on which of these is
selected for editing (by the EQ EDIT PRE/POST
buttons). EQ bands can also be adjusted from
this screen using the mouse to click on a read-
out and adjust the numeric values up or down.
Pre/Post Parametric EQ
Pre and Post Parametric Equalizer graphs
The main EQ graph allows you to display and
edit both the Pre EQ and Post EQ. Pre EQ is ap-
plied to the signal before it reaches the dynam-
ics processing section, and Post EQ is applied
after the processing. (See the block diagram on
the previous page.)
The EQ's IN/OUT
buttons let you
select which EQ
is engaged (on) or
bypassed (off). (You
cannot edit or view
when off.)
The EQ EDIT but-
tons allow you to
select which EQ to
edit, either Pre or Post. The letters Pre or Post
will also be highlighted in the graph background
screen, as a reminder of which EQ you are edit-
ing. (When Final Mix is initially activated, EQ
EDIT PRE is on.)
The EQ VIEWS buttons let you select which EQ
to view, either Pre, Post, or both at the same
time.